Natural Sealer Instructions
How To
It is important that both wood and product have a temperature of min. 59°F (preferably around 68°F) and air humidity of approximately 40-60 %. Make sure that the room is well-ventilated. Untreated floors need to be devoid of dirt, grease, wax, and dust. Previously finished floors require sanding down to bare wood before applying the sealer. Vacuum thoroughly and tack the floor. Shake the Natural Sealer thoroughly before use.
Always remember to test on a less visible spot to check the compatibility of the surface with the product.
- Apply Natural Sealer undiluted with roller, lengthwise, and allow the surface to dry.
- Sand the surface with 120-180 grit and vacuum clean the surface thoroughly.
- Apply a 1 coat of WOCA Water Based Finish. Leave the surface to dry until next day.
- The next day, apply another 1-2 coats of WOCA Water Based Finish (refer to specific WOCA Water Based Finish product for recommended number of coats).