Advanced XP 2K Application Instructions

It is important that both wood and floor finish have a temperature of min. 59°F (preferably around 68°F) and air humidity of approx. 50%. Make sure that the room is well-ventilated for optimal evaporation and drying time.

For the final sanding to bare wood, use grit 100-120 sandpaper or sanding pad. Vacuum thoroughly and tack the floor afterwards, using a tightly-wrung water-soaked mop/cloth. The floor must be completely dry before sealing. When sealing, use WOCA Sealers for newly sanded wood to reduce side bonding.

  1. Apply the sealer if not using a stain. When dry, mix WOCA Advanced Hardener with the floor finish and shake thoroughly before use. Leave the mixture to stand for ten minutes before use, to allow the hardener to activate.
  2. A coat of Advanced XP 2K floor finish should be applied undiluted, using a brush or roller. Leave the surface to dry until next day.
  3. Sand the surface with grit 120-200 and vacuum clean the surface thoroughly.
  4. Apply the final coat of Advanced XP 2K floor finish with hardener (freshly mixed).

The freshly-finished floor is suitable for cautious use after approx. 5-6 hours. Do not place furniture etc. on the floor until at least 24 hours after the final coat of floor finish. The floor will be ready for normal use after approx. 5 days, after which rugs etc. can be placed on the floor.

This site uses cookies to ensure you get the best experience on our website.

Accessibility Initiative Badge