1-877-962 2645 | Mon - Thu, 8am - 5pmFri, 8am - Noon EST
Montage European Oak Care 2017-03-09T00:06:55+00:00

HF Design – Montage European Oak Floor Care

Easy Maintenance and Care Guide

Cleaning Montage European Oak Flooring After Installation

1.Vacuum and/or Mop

Clean dust and dirt off the floor with a soft brush vacuum cleaner and/or a standard dust mop.

2.Mop with WOCA Oil Refresher

Mix 1 cup of WOCA Refresher Concentrate with 5 quarts of water in a bucket. Mop the entire floor with this mixture using a Terry Cloth mop.

3.Let it Dry

Leave the floor to dry for 4 to 6 hours before allowing foot traffic and placing rugs.

Montage European Oak Floor Care using WOCA products.

Regular Cleaning of Montage European Oak Flooring

Use Pre-Mixed WOCA Oil Refresher Spray Bottle. Spray mixture onto the floor and spread evenly with a clean Terry Cloth mop. Leave the floor to dry for 1 to 2 hours before allowing foot traffic and placing rugs.

Watch video for Oil Refresher Spray instructions.

Cleaning After Installation

After the floor is installed it is required to clean the floor using 1 cup of WOCA Oil Refresher mixed with 5 quarts of water (250 ml to 5 liters of water). Mop the floor gently using a wrung cloth mop. The mop should be damp, not wet. Excess moisture may damage the floor. Leave the floor to dry for 4-6 hours before taken into use. Use WOCA Oil Refresher White on white oiled floors and WOCA Oil Refresher Natural on all other oiled floors. Please refer to After-Care Matrix below. (Download WOCA’s  Instructions and Safety Data Sheet)

Please refer to video for Oil Refresher guidelines and instructions.

Routine Cleaning of Montage European Oak Floors

Perform monthly cleaning by vacuuming or sweeping.

When floor is dirty, use mixing ratio of half a cup of WOCA Oil Refresher to 5 Qt water (125 ML to 5 Lt of water) or WOCA Oil Refresher Spray. Dip the mop into the Oil-Refresher mixture and clean the floor with the light wrung mop. If floor is very dirty, it is recommended to work with 2 buckets: one with the solution and one with rinse water.

Mop the floor lengthwise of the boards. Leave the solution on the floor briefly in order to dissolve dirt. Remove dirty Oil Refresher residues with hard wrung mop and then rinse in bucket with rinse water. Always wipe floor with a hard wrung out mop in order to re-establish the protective Oil-Refresher micro film.

Lastly, leave surface to dry for 1-2 hours before taken into use.

Use Oil Refresher White on white oiled floors and Oil Refresher Natural on all other oiled floors.

Please refer to After-Care Matrix below:

Initial Cleaning Routine Cleaning
Laurel Collection

 

 

 

 

Baroque Collection

 

 

 

 

Ferno Collection

 

 

 

 

Portofino Collection

 

 

 

 

Milano

Sardinia

Genoa

Veneto

Abruzzo

Russo

Forli

Palma

Marche

Lazio

Salerno

Valencia

Nord

Castillian

Rhone

Sienna

Taverna

Amalfi

Tuscan

Terrazzo

Oil Refresher White

“”

Oil Refresher Natural

“”

“”

Oil Refresher Natural

“”

“”

Oil Refresher White

“”

Oil Refresher Natural

“”

“”

“”

Oil Refresher White

Oil Refresher Natural

“”

“”

“”

Oil Refresher White

Oil Refresher White

“”

Oil Refresher Natural

“”

“”

Oil Refresher Natural

“”

“”

Oil Refresher White

“”

Oil Refresher Natural

“”

“”

“”

Oil Refresher White

Oil Refresher Natural

“”

“”

“”

Oil Refresher White

Future Maintenance

Natural oil finished floors should never need to be re-sanded. However, over time it is necessary to apply more oil to the floor. Traffic patterns or wear areas can be easily eliminated with this step. Typically in a residential application this is anywhere from 2-5 years after initial use of the floor. WOCA Maintenance Oil provides the floor with additional hard wearing properties. Use Maintenance Oil White on White oiled floors and Maintenance Oil Natural on all others. Please follow directions on the label.

Commercial Applications

General Recommendations:

After installation in commercial areas (high traffic areas) the new floors should be first mopped with WOCA Wood Cleaner 1:40 ratios to prep the floor. Let the floor dry then polish with a coat of WOCA Master Oil in a 1:40 ratio and let floor dry 1-2 hours. Work in 250-300sqft sections. Using a thick white polish pad, pour a capful of WOCA Master Oil into the center of the white pad and begin buffing the floor. Add small amounts of oil directly to the floor as needed. Once you have buffed the WOCA Master Oil into a section, you must remove the WOCA Master Oil from the surface. Remove any excess WOCA Master Oil on the surface using a cotton cloth underneath a clean white pad. Repeat this process with each section. For ongoing cleaning of commercial areas, use WOCA Oil Refresher. However. Please contact the local WOCA specialist for a customized cleaning and maintenance schedule.

Display and Showroom floors are great ways to show the beauty and character of natural oiled floors. To ensure the floors last a long time and hold up to the constant flow of traffic in a showroom or model home the Manufacturer recommends treating these floors as a commercial application by using WOCA Master Oil after installation. The Manufacturer believes this is necessary to maintain the beauty and protect the investment. Please refer to WOCA Commercial Care and Maintenance Guideline and recommend contacting WOCA for detailed step by step process.

Quick Tips & Tricks

DO

Place Felt Protector on moving furniture

Place door mat in front of main entrance

Protect flooring by covering wall to wall during construction with 3” overlap to avoid paint, spills, sheet rock dust, etc.

Make sure any adhesive is immediately wiped off prior to drying

DON’T

Don’t use any tape on the Floor including Blue Tape

Don’t use Mineral Spirits

Don’t leave spills, wipe up immediately

Don’t use Microfiber (use only Cotton or Terry Cloth)

Touching Up Montage European Oak Flooring

Touching up European oak flooring is simple and effective with WOCA's woodcare products.
Care & Maintenance Guide for HF Design European Oak floorsRemember to stay safe using WOCA products to treat your HF Design European Oak Flooring.
HF flooring touch ups are easy with WOCA

Step-By-Step Instructions

  1. Apply a small amount of the Montage Touch Up Stain on a cloth or sponge and rub it into the area. Make sure to rub oil into the floor until the area is uniform.
  2. Wipe off the excess Touch-Up Stain with a soft cloth until the repair looks uniform and make sure the stain blends in with the rest of the floor.
  3. Leave Touch-Up Stain to dry for 1 hour.
  4. Then apply a small amount of the WOCA Master Oil with a cloth and rub it into the area.
  5. Leave Master Oil to dry over night.
  6. After 1 week the surface is fully hardened.
  7. Then continue routine cleaning with WOCA Oil Refresher as per the recommended Care & Maintenance Instructions

Recommended WOCA Products

Use WOCA Master Oil to protect any high traffic Montage European Oak Floor

$48.00$197.00 Select options

WOCA Wood cleaner

$34.00$65.00 Select options

WOCA oil refresher

$45.00$101.00 Select options

 WOCA Maintenance Oil provides Montage European Oak Floors with additional hard wearing properties. Apply to any commercial or high-traffic surface for ultimate protection.

$33.00$64.00 Select options